Stove with boiler CPV-2

General arrangement cooker with tubular heater is basically similar device stove oven. The two boards are the same size and order of movement of flue gases. Their difference lies only in the fact that the furnace stove with boiler mounted U-shaped coil made of pipe diameter of 40 mm.
Emeevik consists of an upper and lower reservoirs: the lower fed cold water, and from the top to the heating system goes hot. You can use the coil to heat water in a separate container.
For a stove with boiler suit all types of solid fuel. In order to reduce heat loss during prolonged frying plate furnace nonconductor special removable visor, the lower part of which is closed with asbestos sheets.
Slab above construction can be installed in the bath. In this case, it should be removed from the oven and make a conclusion in an oven-hot stones. In the event that there is a summer kitchen in the room with steam room and sauna rest room combined with kitchen, stove with boiler positioned so that the stove and furnace is in the kitchen, and the hot gases leaving the furnace, stove through an opening in a wall partition.
Materials for masonry:
- Bricks, including refractory, - 175 pc.
- Grill grate 250 x 180 mm - 1 piece.
- Furnace door is 250 x 205 mm - 1 piece.
- The ash-pit door 1Z0 x 140 mm - 1 piece.
- Cast iron stove component 5Z0 x 900 mm, with two rings - one piece.
- Steel angle Z0 Z0 x x 4 mm - W, 2 m;
- Welded coil 040 / W (length 5.0 m) - 1 piece.
- Seamless pipe 048 / W (1.5 m) - 2 pc.
- Steel roof upholstery floor 10Z0 640 mm - 1 piece.
- Steel sheet predtopochny 500 x 700 mm - 1 piece.
- Asbestos sheet 10Z0 640 mm - 1 piece.
Laying sequence is as follows:
1-N-th series - solid masonry with respect bandaging joints. In the SW front row in place device ash brick stesat need to form a groove.
4th row - setting the ash-pit door, forming the output channel between the left wall and the oven. -Cleansing: The drawing shows a brick, which is taken out, instead set the door cleaning.
5th row - masonry is similar to the 4 th row with the correct ligation seams overlapped cleaning.
6th row - Set the oven and grate.
7th row - setting coil formation of the combustion chamber and the channel between the oven and the left wall of the plate.
8th row - setting the firebox door.
9-10th series - complete formation of the furnace and air holes between the oven and the left wall of the plate.
11-12-th series - masonry is in accordance with poryadovkoy. The upper part of the oven greased clay mortar thickness of 15-20 mm.

13th row - installing iron plates and frames made of steel angle.
Share with your friends a link to this page, or add to