Connection woodwork glue

No glue is almost impossible to do with the connection details. When gluing wood need to use glue, which must be either transparent or light, did not change the color of the wood, not too quick to learn, easy to removed the excess, and inside seam it would promote preservation of wood from rotting and penetration of microorganisms inside. In addition, most have a water-resistant adhesive.

Adhesives
All adhesives can be divided into natural and synthetic. Depending on what ingredients are used in the preparation of natural glue, they are animal, vegetable and mineral. The manufacture of synthetic adhesives are only man-made compounds.
Any glue that need to work, consists of several components: the actual adhesive, solvent, as certain of consistency, curing agent, which helps him to grab and connect parts, and preservatives that protect the treated area from the effects of insects, microorganisms and different substances, destroy the structure of the wood.
Among the natural adhesives are most commonly used bone, prepared on the basis of bone meal. But these adhesives do not respond well to moisture, so if, for example, in the attic will make a shower or bathroom, to bond better to take a different glue.
Casein glues are based on milk protein. They are very tightly bonded to the surface, but as a solvent is used lye, which stains the wood.
Clay K-17 is useful for pure bonding large surfaces, it forms a thin film and did not harden.
PVA glue, or polyvinyl acetate dispersion, quickly grasped and therefore requires speed operation. He is a white liquid that becomes transparent when dry film. The adhesive for bonding most universal parts.
Carpenter's glue can be used multiple times. You just need to heat it in the fire.
And joiner, and bone adhesives sold in granules or chips that are home turned into a sticky mass. If you bought the glue in the form of chips or pellets, it can immediately pour in the hot water, stir and bring to simmer until dissolved.
If the glue is in the form of tiles, then before you put it in the water, it is ground, then pour in the tank with cold water and leave for the day as long as he is not fully swell. And then shift the pieces in another bowl and set about the procedure itself bonding. Ready glue sticks should run away from, which is used for stirring, it should be thick in consistency and remind fat sour cream.
In order to prepare the glue will need to purchase a special device - kleyankoy. You can replace two conventional pans, one of which should be a little less to calm could be fastened to the sides of the other. In a smaller pan pour water and covered with glue and water is poured into the other, prepared to glue burnt. If, during the preparation of the adhesive foam is formed, it must be periodically removed.

Most adhesives are not able to stand for a long time and the next day at room temperature acquiring smell of rot. To glue stood a few days, when cooking, you can add a few grams of phenol rate of 1 g per 1 liter of glue.
Now prepared adhesive can be applied to the surface. This will require either bristle brush or lime bark, a piece of which the pre soak. In any case, the adhesive is applied to the surface of a thin layer.
Share with your friends a link to this page, or add to