Side connection

Side connections are also called cohesion. Most often, this compound is used in the construction of floors, doors or gates. This is quite a strong connection. Large arrays, which are the result of such a compound, additionally mounted transverse planks or boards.
If the items have a smooth surface and side edges of the compound just stick together, then this connection is called the smooth side fugu (Fig. 59).



Сплачивание на гладкую фугу

Fig. 59. Rallying the smooth puffer.



If in every detail on the side of a groove along its entire length, into which the connecting rod, this type of connection is called the side the slide rail (Fig. 60).



Сплачивание на вставную фугу

Fig. 60. Rallying the slide fugue.



If the sides of the quarter and removed parts are attached with them, such a connection is called a side in the quarter (Figure 61).


Сплачивание в четверть


Fig. 61. Rabbet.



The next type of connection - lateral tongue and groove, which has several types depending on the quality of the ridge. This groove can be a triangular (Fig. 62) and rectangular (Fig. 63).


Сплачивание в треугльный паз и гребень


Fig. 62. Rallying in treuglny tongue and groove.



Сплачивание в прямоугльный паз и гребень



Fig. 63. Rallying in pryamouglny tongue and groove.



For the device roofs use the following type of lateral connections, which contributes to better rainfall runoff from the surface and greater protection cover from the damaging effects of atmospheric phenomena. This type of connection is called a lateral overlap (Fig. 64).


Сплачивание внахлест


Fig. 64. Rallying overlap.



Details you need to connect this way: the bar is placed under the lower rail thin nails and fix the upper edge of the side part, then set the next bar, making its lower edge a little overlap, equal to 1/4 the thickness of plates and also secured her a few nails.
Also, to connect multiple parts into one with only one can be used with the tip of rallying (Fig. 65).



Сплачивание с наконечником

Fig. 65. Rallying with the tip.



This type requires the same notch on the side of the single components and the end face of the parts. Most often it is used in the preparation of the parquet floors.
As a decorative technique is most often used side connection with the overlap (Fig. 66), which not only decorates the surface, but also contributes to the great sound and heat insulation.


Сплачивание с перекрытием


Fig. 66. Rallying with overlap.



This is done as follows: first, a period equal to half the width of the strip, plank first row. Then on top of it to the details set the second row, which closes the void.
Share with your friends a link to this page, or add to